| Rear Shot Random Spec | |
 |
|
| Random Spec | |
 |
|
| Josh Ziemba's 2005 Nissan Sentra SE-R Spec-V | |
 |
|
| Josh Ziemba's 2005 Nissan Sentra SE-R Spec-V | Josh Ziemba's 2005 Nissan Sentra SE-R Spec-V |
 |
 |
| Josh Ziemba's 2005 Nissan Sentra SE-R Spec-V | Josh Ziemba's 2005 Nissan Sentra SE-R Spec-V |
 |
 |
Additional nissan sentra Questions:
Hi people! (: so how dark should I do my tints for a black 2007 nissan sentra? Like what percentage?
Answer:20% is plenty dark enough and is usually legal wherever you are. Plus you can still see out at night.
I locked my keys in my car last night and I don't really have any money to call AAA or a locksmith. I have a 2005 Nissan Sentra. Is there any other way I can unlock it?
Answer:I gently pull back on the back top corner of the passengers side door frame insert my wallet that 1/4 inch will give you room to use a 1/8" metal rod approx 3 feet long with a 90 degree bend on one end about a inch bent to hook the door lock and pull backward. Strong fence wire like top wire of chain link fence. But not your car antenna it looks funny when you bend the end and is just about 4 or 5 inches to short. Passengers side should you tear the rubber your ear is not right there listening to the wind noise. Coat hanger might not be strong enough to pull back that lock... Good Luck
My 97 nissan sentra's engine is going down, and I have an other engine with transmission ready to go. I need some good ideas about safe easy and best way to do that.
Answer:I just hope you have the entire car the motor and trans came out of because pedals clutch cable and engine control module and engine compartment wiring harnesses are different. And the drive axles may be different. even the hole in the floor for the shifter linkage may be different.
How do I switch out the shift knob for an automatic transmission Nissan Sentra 98'? I unscrewed the 2 screws to take the original one off but it seems to be attached to some white rubbery wire. Can I even switch itout for a custom one I found? Thank you.
Answer:SHORT ANSWER NO! THE ONLY THING YOU COULD DO IS LOOK TO FIND AN AFTERMARKET (B&M MAYBE) SHIFT LEVER.
I want to sell my 2007 Nissan Sentra and get a cheaper car that I can pay off in a year, because I will become a full time student. The car was in an minor accident and had some slight water damage that was repaired by Nissan. I currently owe $13,822.00. Anyone with experience selling their car to Carmax have any idea what kind of figure they might offer me? I just want to sell it to them.
Answer:Dealing with carmax, they will likely offer you around 30 to 40 percent lower than trade-in.
how to replace a 1998 nissan sentra power steering pump belt? I have figured it out! You have to loosen the two bolts on the mechanism by the power steering pump and then, using pliers, squeeze the long bolt forward so the power steering pump pulley wheel moves to a position where you can slip the belt right on. It is actually very easy! Less than 15 minutes!
Answer:
How does the intelligence key for the 2007 Nissan Sentra Work? Which models include it?
Answer:I key cars have a lock button on the door handle made out of rubber. there are antenna around the car that picks up the I-Key transmitter and the car knows your near the trunk or door push the button and the car unlocks or locks and you never have to take the key out of your pocket or purse. Really handy but a bit complex push button start is nice too. Ca beeps and makes different sounds if you leave keys inside.
My 1988 Nissan Sentra keeps breaking flex plates. What could be causing this? I have a new flex plate, torque converter and transmission I am installing in the car in the hopes that this will resolve the issue. But I need to know how much torque i should use installing the flex plate>
Answer:Buy a manual or ask a garage that has a manual for the torque specs. If it keeps breaking the flex plate my best guess is you are missing a dowel pin that locates the engine/trans assembly at true center. You may have one pin missing, or both. Without one or both pins the crankshaft and torque converter are not in perfect alignment causing the plate to fail. Did the old converter have a trashed bushing in the hub? If the bushing was severely worn, or the stator on the trans shows significant wear you are probably missing a dowel pin. If the engine was changed make sure there is no pilot bearing/bushing from a standard trans in the back of the crankshaft.
I recently purchased a set of Infinity speakers for my 2004 Nissan Sentra. I was trying to install them but could not figure out how to remove the door panels on the front doors. How do you remove the door panels on a Sentra? Also, I am electronically knowledgable, but any information that someone could give on how to remove the tweeters and front speakers and info on how to install new ones would be appreciated. Thank You.
Answer:Crutchfield.com has a manual they sell that tells you how to take your car apart. Go on the website and click on outfit my car and then choose the manual for your car. The manual tells you how to install your speakers (front and rear) and your deck installation as well. As for tweeters you might need to talk to a professional and they could possibly give you some info on tweeter installation. link: http://www.crutchfield.com/cgi-bin/autoinfo/autoinfo.asp?lp=%2fapp%2fCar%2fMyCar.aspx
I have a nissan sentra and the transmission is going out. I need help.
Answer:the interchange is as follows 89-92 sentra
